Power connection
How to connect power input to the TAG-E is described on separate page.
Mavlink connection
Connection to flight controller and all configuration is described on separate page.
Direct connection of Sony ILX-LR1 #
This manual is about TAG-E connection and installation for direct connection (no gimbal) to Sony ILX-LR1 camera with cables included with each TAG-E unit.
STEP 1
Connect USB-C cable to TAG-E port labeled “USB”.
Connector needs to be inserted straight, make sure you do not use excessive force!
STEP 2
Connect exposure wire to the camera “EXPOSURE” pin on the camera Molex 6pin connector.
This step is crucial and must be done properly!
CONNECTION
Interconnect white wire (color is based on original connector included with the camera) with red wire from our USB-C cable.
Soldering may be necessary.
STEP 3
Connect USB-C cable to the camera
Camera configuration #
TAG-E works with the camera in default configiration, however, if you used other remote control systems, you may need to check these options:
STEP 1
Enter camera MENU and navigate to:
SETUP -> USB -> USB Connection Mode -> PC REMOTE
STEP 2
If you previously used other system for remote control using WiFi, make sure the WiFi is disabled or remote controller is disconnected to avoid control interferrence.
NETWORK -> WiFi -> WiFi Connect
OFF
STEP 3
Configure save destination for your data.
NETWORK -> Cnct./PC Remote -> Remote Shoot Setting -> Still Img. Save Dest. -> Camera Only
