Warning #

Entire accepts input voltage of 5V ONLY!
Higher voltage can harm the Entire and also connected camera via USB!

  • All input and output pins of 5V and Ground are interconnected.
  • Input power is interconnected to Port A/B, EXT, PORTMULTI.
  • Make sure that external device can handle 5V input, or does not output higher voltage to the Entire.
  • If you are not sure, contact us at info@airpixel.cz or disconnect the power pin by removing from cable connector.

Power up #

Connect power cable to PWR connector of the Entire.
Connect 5V power to the Futaba servo connector.

power
Entire_conn_PWR

Short list of power input for the Entire:

LED blinking
When Device is powered up, LED goes RED as signalization of system startup process.
During the startup, LED will blink white few times as sign of proper system load.
Startup process takes approx. 20s. Then blue color appears and Entire is ready for camera connection

Configuration #

Entire configuration is done via wireless connection. You need any WiFi equipped device with web browser for configuration and control.

Connect WiFi #

Open your Phone, Laptop, PC, Tablet and open WiFi connection. Search for SSID named Entire_xxxx where “xxxx” is unique ID code of your Entire. You may get warning about internet unavailability at the hotspot, this must be confirmed OK.

Open Entire's GUI #

Open web browser and as URL enter:

http://entire

 

At some devices this url may not work (especially iPhone). Please follow this address if first one is not accessible:

http://192.168.10.1

Overview page
At landing page you will get all important information together in panels. If the Camera or Wi-Fi, SD card or etc. is properly connected, proper block will be highlighted. At the bottom of page you can switch from overview to Control page, where you can control connected camera from the mobile phone / tablet or etc. Main MENU is accessible by clicking to the icon in the top left corner.

Full description of main page is here.

Warning

Entire accepts input voltage of 5V ONLY!
Higher voltage can harm the Entire and also connected camera via USB!

  • All input and output pins of 5V and Ground are interconnected.
  • Input power is interconnected to Port A/B, EXT, PORTMULTI.
  • Make sure that external device can handle 5V input, or does not output higher voltage to the Entire.
  • If you are not sure, contact us at info@airpixel.cz or disconnect the power pin by removing from cable connector.

Power up

Connect power cable to PWR connector of the Entire.
Connect 5V power to the Futaba servo connector.

power
Entire_conn_PWR

Short list of power input for the Entire:

LED blinking
When Device is powered up, LED goes RED as signalization of system startup process.
During the startup, LED will blink white few times as sign of proper system load.
Startup process takes approx. 20s. Then blue color appears and Entire is ready for camera connection

Configuration

Entire configuration is done via wireless connection. You need any WiFi equipped device with web browser for configuration and control.

Connect WiFi

Open your Phone, Laptop, PC, Tablet and open WiFi connection. Search for SSID named Entire_xxxx where “xxxx” is unique ID code of your Entire. You may get warning about internet unavailability at the hotspot, this must be confirmed OK.

Open Entire's GUI

Open web browser and as URL enter:

http://entire

 

At some devices this url may not work (especially iPhone). Please follow this address if first one is not accessible:

http://192.168.10.1

Overview page
At landing page you will get all important information together in panels. If the Camera or Wi-Fi, SD card or etc. is properly connected, proper block will be highlighted. At the bottom of page you can switch from overview to Control page, where you can control connected camera from the mobile phone / tablet or etc. Main MENU is accessible by clicking to the icon in the top left corner.

Full description of main page is here.